11-02-2005, 08:17 PM
|
| *Registered* | | Join Date: May 2004 Location: United States
Posts: 198
| |
Originally Posted by GAWnCA OK, I've seen the foam cutter from 8Link as well and would like to build one that will cut up to an 10" x 20" x 96" block of foam. I would like to know where to get the parts, motors, controller, power supplies for both the controller and the cutting wire. I know that all teh motors have to drive is the cutting wire so I guess whatever was used on that system would be fine. Any suggestions will be greatly appreciated. | http://www.hobbycnc.com/foam/4aupcwh...aupcwhcpkg.htm
Dave Rigotti
HobbyCNC.com |