I have a design problem and as many amoung you have retrofitted a Seig X3 I should be able to get an answer here.
Problem is on the Y axis of the Seig X3 Mill with the original screw it is not supported at the back. As I am going to fit Ballscrews I need to support the ball screw and the rear of the screw is where I was wanting to fit the thrust bearing.
Could anyone who has done this retrofit give me some assistance as to how to do this as I am wanting to order my ballscrews and as they are going to machine them for me I need to be sure of the setup.
Jim |