[dneisler]

I posted the same question on the support group, so far just one response. I am getting iritated due to I am asking you what is need to complete the project and you cannot/wont tell me what you recommend. I am not asking what you are using, just what you recommend to users. I can find a case, and a power supply, but do you recommend 24v, 36v, 48v, or what. How amps needed? Where do you recommend fuses to go? before board, before motors, both? What size? Normal or fast blow? What other dodads do I need. I want to get this all ordred so I can get this going soon.



You are correct, I know very little about CNC, but I do know the basics of Electronics and electricity.