Originally Posted by James Newton I forgot to say... Nice looking mill there... Is that your design or a clean execution of someone elses? |
It is mine from tip to toe, actually. Not a single idea off the internet went into that design, but then how many ways are there to make a sliding table? Not that many. The linistepper is the only element I drew on from somebody else, but even linistepper was so close to what I allready had made myself, just with bc337s thrown in between pic and tips. And my software was doing full and half stepping only whereas linistepper programming is much much bigger than mine. Which reminds me, I was going to do some analysis of linistepper assembly to try and cut the number of lines of code.
Also, how hard would it be to convert linistepper to use l298 instead of tip122? I'm thinking chopper driven by linistepper logic. Now that would be a hit!
