Well folks I have completed my drivers, the knee-mill and I can tell you that linistepper and dremel can dig into a piece of pine like hot knife through butter!
I just did some engraving on the back piece of a pcb and it works nice. I even made a mistake of inputting -2mm rather than -0.2mm and it just dug into the pcb and started writing.
So I can conclusively say that linistepper with 1.2A step-syn motors works like a charm!
I'm using a 12v ATX PSU and an additional $5 12v computer case fan is blowing across the linistepper to provide some fresh air to those alu coolers. |