The picture should be somewhere here. My memory was faulty, they are a bit longer than 3/4" but shorter than 1". You have to keep your wits about you putting them in the spindle to avoid pinching a finger. They do not seem to have a part code other than ER32 Short and they are ETM by Iscar also balanced for 20k rpm.
If you do take your table off any chance of pictures? I would like to see what is underneath. I took delivery of a GR510 a few weeks ago and tried to make sure I got enough options I would not be limited; i.e., 15k spindle, 24" Z travel and a few others. Fortunately I am the one deciding what gets included. |