Hey thanx,
I didn't have enough pull with the purchase of the machine options!
I did notice that option but the head eng. had other thoughts!
Now he is retired and we're stuck with what we have!
I think we can work around this because we will be putting a vacum table on top of the alum plate and I was thinking of mostly just useing colleted tooling!
Not too many clamps to worry about!
I did get my post for EZ-Cam to let me go into incremental G91 to raise Z+4.0 and back to Absolute G90 but only after tool changes! If I try this before tool change machine gives Z overtravel. I know its also relative to where I use G54 Z offset also.
I e-mailed EZ-Cam and there gonna try and help.
Next I'll try the Haas installer and see if he has any suggestions.
He help set up a shut down program which does what I need before and after tool changes but I can't seem to get that to work in my posted programs!
Thanx, Larry |