This is strictly an as-is no guarantee listing.  I was told that the mill was working, but they were having some issues with the spindle.  You get the servo mate asembley as shown and the spare card shown.  I'll package it up as best I can. I'll enteratin "reasonable" offers. 

The cap shown is included.  I disconnected it, but then I found a cap I liked better for the application so I am leaving this one with the servomate. 

 already looked to see what these cards are being listed for on Ebay so I'll heckle low ballers mercilessly. 

I have gutted the machine, and am retrofitting it to Mach 3 control using a Smoothstepper and step direction servo drivers.  I never tested any of the Hurco electronics. 

Anybody who has new never used G320X servo drivers I would consider a trade for 4 of them.