This is a used Power Feed that fits my Industral Hobbies bench top milling machine. It will also fit all the RF-45 type of mills that have 5/8 shafts which is almost all of them.

It works fine and really only has 10 or 20 hours of on time. Their is a few scrathes but nothing real bad. I did need to make a mounting bracket that holds the unit to the table because I over tightened the stock mount once and it cracked. The new one is a sold block of 6061 so it is srtonger than the stock cast part. I think it looks better too. I was looking at the powerfeed more closely and it looks like the top of the motor housing has a small crack. It is in the picture but you can hardly see it. I don't really know where it came from. I dont see any real efect from it.

Installing it is real easy, just remove the right hadnwheel install the drive gear and set it on and adjust the height so you have just a bit of play in the drive gear. It has a high speed button which comes in handy for surfacing Aluminum.

If you have a smaller mill or the shaft is smaller than 5/8 I will inculed the drive cuppler from my milll. If you added a bushing it would allow you to adapt the unit to a G0704 mill or others.

I will pay for shipping and you should have it it about 3 to 4 days with the USPS Prioioty Mail.

If you have questions I check my Zone PM often.

Paypal only

Thanks

Dave