This is a Bridgeport Clone, same machine that Jet sold before they started buying communist Chinese machines. This one is one made in Tiawan. The table is 8 x 49 (could be 9 x 49...getting old). It has around 100 HONEST hours on the mill itself. I installed Zeiss-Jena precision ground ballscrews on X and Y (.0005 per 12"). It has dual precision bearings on both screws. It is a belt drive head but it does include a VFD to control spindle speed. The spindle motor is 220 3 phase. The table has no dings, dents or drill holes, just a slight dark spot where the vice was attached. The servo mounts are from a Mitutoyo kit which is the same hardware as a number of other companies. The ballscrews have about 20 hours of use. Since it has been in storage some of the oxide bolts have gained some surface rust, it will in no way effect the performance of the machine. If I was in better health I would spend 20 minutes and clean them up, they would look like new. I paid more for the mill alone then what I am selling everything for. The mill is located in Eastern Iowa - Maquoketa

Thanks for reading everything

Charlie

chuck AT m1restoration.com