Bridgeport Rigid Ram CNC mill for sale. Purchased from machinery dealer, gutted
all the outdated electronics (had a punch-tape reel-to-real system). Retrofitted
with all new modern gecko drive control. Original stepper motors, new VFD (can
run 3-phase or single phase 220 by default), wiring and water tight metal
protected conduit, flood and/or air coolant, splash tins, too much to list...
Software runs in on a PC in EMC2 (Linux operating system).

The manual jogging is done by the MPG control panel was built from scratch Bridgeport. Joysticks operate rapids, MPG wheel from a FANUC system bought as new old stock. Push-buttons from arcade game purchased through an online wholesaler with LED lighting (originally used 12-volt condescend bulbs). Zero touch-off. 3-way switch-button toggles the axis to control; pulled from original machine - cleaned and polished.

Its about the size of four refrigerators stacked in a square. 30 cubic feet in floor space I estimate off the top of my mind.


Must go!

call Erich 609-707-0289